By -
VDA-QMC has published much awaited Automotive SPICE Guideline book (referred as Blue-Gold Book due to main page colour). It is available for purchase in Euro 50 on VDA webstore http://webshop.vda.de/QMC/en/automotive-spice-guidelines_1stedit2017 
The guide book is available only in hard copy as of now. 

Comments

Post a Comment

Popular posts from this blog

Automotive SPICE v3.0: Plug-in Concept

By -
Image
Automotive SPICE v2.5 has Engineering Processes as ENG.1 ~ ENG.10 covering system & software domain processes. Automotive SPICE v3.0 has been upgraded with concept of "Plug-in" domain specific processes. System Engineering process have been separated with SYS.1 ~ SYS.5 on top level of architecture. Domain specific processes, i.e., Software Engineering have been defined as SWE.1 ~ SWE.6. The placeholder for Hardware Engineering (HWE.1 ~ HWE.4) & Mechanical Engineering (MEE.1 ~ MEE.4) have been created. In future, with the availability of Hardware engineering & Mechanical Engineering processes, Process scope can be enlarged.  For details visit www.iqiconsulting.com or write to us on contact@iqiconsulting.com
Read more

Maturity Level concept using Automotive SPICE

By -
CL & ML : Differences Characteristics Capability Level (CL) Maturity Level (ML) Result Applicability Process Organization unit Scope Process & CL §     Any number of processes can be selected (mostly – VDA Scope) . §     CL can be defined for respective process . §     Pre-defined set of processes for respective ML Scope Project §     Single project (mostly) OR §     Multiple projects §     Class 1: 4 instances (Minimum) §     Class 2: 2 instances (Minimum) §     Multiple projects to represent “organization unit” appropriately. §     Minimum number of sample shall satisfy “Class” of assessment rule. Rating Aggregation   §     No aggregation within project (mostly) §     For multiple projects - aggregation as per rule (R1/R2/R3) can be applied. §     Aggregation is done as rule rating rule o    R1 – Rate BP/GP & aggregate o  
Read more

Concept of SUP.9 Problem Resolution & SUP.10 Change Request Management

By -
Image
Both processes leads to changing project work products which are already baselined. To update the baselined work products, change (control) management (part of Configuration Management Process) is called. However, before calling change management process, the analysis of defects / change request shall be completed. The concept of their implementation is shown below: Automotive SPICE defines two processe s; SUP.9 Problem Resolution Management (PRM) & SUP.10 Change Request Management (CRM) Process. Few organisation manages these two processes with same tool & combines the flow but identifies with categorisation.  Difficulty is seen when CMMI based organisation tries to fulfil the CRM requirements using SG2 requirement of CM Process Area of CMMI. Some of the activities are not get defined completely. By adding additional requirements as indicate above (also defined in Automotive SPICE SUP.10), the compliance to SUP.10 can be achieved. For more information on any of t
Read more